Widze ze słabo piszesz po polsku i używasz jakiegos translatora , pisz może w jezyku angielskim , bedzie łatwiej i Tobie i nam:)
: 08 mar 2012, 09:15
autor: BlackT
OK, you can write on polish
New rims
(not polished yet)
steering wheel
Modified Tacho
(not finished yet)
thats all for now
: 08 mar 2012, 10:07
autor: Tigeros
That's much better with Bolero rims
: 08 mar 2012, 18:03
autor: Wostok
Could You write tyres size??
: 08 mar 2012, 20:47
autor: s80
Witam panowie ,,anglicy.. co to za panel pod radiem?
: 10 mar 2012, 21:44
autor: BlackT
tyres 225/45 r 17
i didn`t understand about panel?
: 10 mar 2012, 22:19
autor: deejay.ftb
s80 pisze:co to za panel pod radiem?
to klima jest.
BlackT pisze: i didn`t understand about panel?
s80 asked about the air conditioner control panel - it is kind of rare in audi 80 B4, isn`t it?
the engine job you have done is impressive - how much horsepower/torques it puts out at the moment?
Bolero wheels are marvellous too but tyre size ruins all the appearance - they are utterly massive! I think 205/45 or 215/40 would be a better choice :mrgreen:
-60/-60 suspension will be great but I am afraid your current tyres would not fit into the wheel arches, and apart from headlights you should go for a S2/cabrio front bumper as well.
I dont know power/TQ of engine, the nearest dyno is 300 km away
I will put 205/40 tyres
About suspension, I like when car is flat. But now front of car is lower 20 mm in regard to rear of car. Suspensions are original. When i put 60/60 will my car be flat,or front of car will be lower in regard to rear of car?
Front bumper S2 is mision imposible in Bosnia and Hercegovina.
Headlights maybe
: 11 mar 2012, 09:49
autor: Mabrothrax
Front's allways aproximetly 20mm higher than the rear. To flat whole car at same high You'll need like 80/60, 60/40 etc
: 11 mar 2012, 15:40
autor: BlackT
So 40 mm front, 60 mm rear? :?: For flat car?
: 11 mar 2012, 15:44
autor: Mabrothrax
60 at front, 40 rear. And it will be at the same hight.
I know is much beter to put 6A, but i rebulit this ABK engine so i want to chip it.
What do you think is it posible to get 130 PS from this engine with K&N filter,beter exhaust system and chiped ECU